I ve made sure there are no obstacles and that the sensors are aligned properly.
Garage door will not go down unless i hold the button.
First check the sensor lights.
Garage door won t go down most common problems when a door won t go down.
Yes there is a problem with the photoelectric eyes.
It just opens an inch and stops.
Depending on the brand of garage door you have one of the sensor lights may flash dim or go out completely when the beam is interrupted.
The remote control in my car will not work at all.
When you pressed the button did the opener lights blink at you.
Can you hold the button down to make the door go down.
To open my garage door i have to hold down the button on my wall until the door is at least halfway up.
If an operational problem exists and the garage door opener will not close the opener can be forced to close.
After i hold the button down to close it the sensor lights come back on.
Hold your transmitter up near the selected button pressing both the garage door remote and the selected in car transmitter button simultaneously.
I have a genie intellicode.
When the door is up the sensor lights are off.
Something is blocking the beam either the sender or receiver is misaligned kicked.
Check for interference from adjacent photo eye sensors of any brand.
Press and hold the wall console button until the garage door is completey closed.
The garage door will open fine but won t close w the remotes and will only close with the one mounted on the garage wall if i hold it down until the door has closed completely otherwise it just clicks and the light on the garage door flickers.
My garage door will not close unless i hold the button down.
Door starts down then stops before it is closed.
This sets the in car transmitter to be your garage door openers make transmitter but you are not done.
Hold down on the buttons until the in car red light flashes rapidly.
If i lift my finger off the button before that point the door will stop and then i have to press the button again and the door will go back down.